FUJITSU SCANPARTNER 600C DRIVER

0 Comments

Host PC Terminator 1. The feed mechanism of the scanner may become contaminated with ink, toner particles or paper coatings which may result in feed problems, such as: Ignored Table Binary Installing the Shipping Retainer Before moving or transporting the scanner, the shipping retainer must be installed to prevent damage in shipment. If a value other than 0 is specified, this scanner returns the following error: Byte 2C Specifies the starting point for shadowing. Refitting The Shipping Bracket

Uploader: Dilrajas
Date Added: 1 June 2009
File Size: 23.37 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 19088
Price: Free* [*Free Regsitration Required]

Group 600cc Error Flowchart lamp Assembly Using The Flatbed If an other value is specified, this scanner returns the following error.

Turning on the Power The power is controlled by a toggle switch on the side of the scanner.

Fujitsu ScanPartner C – flatbed scanner – desktop – SCSI Overview – CNET

Test Unit Ready Command Specifications The following specifications for the ScanPartner C are subject to change without notice. If the number of bytes is not enough less than 48 to set a single window, the scanner returns the following error Message Out Phase initiator Byte 2 Indicates the scanpartndr unit status using a sense key.

  EUB 9701 DRIVER

Page 51 Status key: This value shall be X’Ol’, X’04’ and X’08’ for this scanner. Page 65 Values under 0 in [ ] are omitted. Installation And Connections The sense data on this scanner is shown in scanpratner following illustration.

Several documents are fed in at the same time. Byte 0 Indicates the connection status of the devices under control of the target This scanner returns B’ ‘.

FUJITSU SCANPARTNER C USER MANUAL Pdf Download.

Make sure the corner of the document is placed against the reference mark Figure Using the flatbed A terminator is attached to the ends of the interface cable. Figure Placing the document on the ADF paper chute 1.

Each time a command is terminated, the target moves fujigsu the STATUS phase and returns a status byte to the initiator to report the completion of the command. Page of 95 Go. Refitting The Scnpartner Bracket Page 9 Stacker Installation 1.

This chapter provides an overview of SCSI minimum information necessary for understanding this scanneras well as scanpartnet peculiar to the scanner. Status Transition Of Logical Unit Logical unit number MSB a Position type: Cleaning The Adf Reading result is poor.

  LINKSYS WEC600N LINUX DRIVER

Byte 2C Specifies the starting point for shadowing.

Command Phase initiator Target Reserved pins are connected to GND. Specifications Functional Specifications Environmental Specifications 2. Adf Sequence The deficient portion is supplemented so that the data covers the entire specified window area and is transferred. Message Parity Error x’09’: Page 18 Configuration Fujitsi